The backbone components have all been fitted and glued. They have slotted connections, egg-crate fashion, with all of the bulkheads. Further into the project all of those junctions will be strengthened with structural epoxy fillets.
The sheer clamps have been scarphed into lengths sufficient to span the full length of the boat, from available shorter lengths. Before that they were also bevelled along both edges to remove excess material to save time later planing them to shape. The sheer clamps are the major strength members along the deck edge. Normally they would sit flat against the inside of the hull skin but with these designs I turn them diagonally across the corner for a cleaner and lighter detail that also has a better balance of gluing area between the components that are being joined.
Now Michael is fitting the hull stringers. With this method of construction the stringers are arranged to suit the different regions of the hull skin. In the photo below you can see the sheer clamp, spanning the bottom corners of the bulkheads. Just above that is a topside stringer. There will be another similar stringer close to the chine that will accurately align the upper side panel.
The other full-length stringer that is in place is the tangent stringer that defines the edge of the curved portion of the hull that is laminated from thinner plywood. On top of the hull there is a stringer partially slotted in, defining the other edge of the curved panel.
Below the tangent stringer is a short stringer at the right in the photo. This is an additional stringer needed to fill in the space where the side panel increases in width due to the tightening of the radius toward the bow.
In the foreground are stringer lengths that will be scarphed together into the long lengths required. The angles have been planed and are ready for gluing.
 | |||||
| Didi 950 with hull stringers being fitted. |
0 komentar:
Posting Komentar